Dell PowerEdge M820 Systems Manuel de l'utilisateur - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dell PowerEdge M820 Systems. Dell PowerEdge M820 Systems 26 pages. Dell poweredge blade servers getting started guide
Également pour Dell PowerEdge M820 Systems : Information Update (38 pages), Notes de mise à jour (27 pages), Manuel de l'utilisateur (23 pages), Informations importantes Manuel (35 pages), Manuel de mise à jour (32 pages), Manuel de mise à jour (28 pages), Manuel de l'utilisateur (22 pages), Manuel de démarrage (12 pages), Manuel du propriétaire (3 pages), Manuel technique (46 pages), Manuel du portefeuille (27 pages), Manuel de démarrage (14 pages), Manuel de démarrage (12 pages), Manuel technique (47 pages)

Rev 1.00

After loading the .pfw file, both the software and firmware will be programmed onto the

10GbE PTM.

Note The update process takes a few minutes.

At the end of this process, the following message will be displayed at the prompt:

# Received update image successfully. Changes will take effect after

next reboot.

Step 6. Exit the 10GbE PTM CLI to the CMC command line. Run:

# exit

Step 7. Power cycle the 10GbE PTM for the firmware to take effect. From the CMC command

line type the following command:

$ racadm chassisaction -m switch-<n> powercycle

Step 8. Wait for 20 seconds, and then connect to the 10GbE PTM. Run:

$ connect switch-<n>

You will be able to view the progress of the SW update.

Step 9. At the end of a successful SW update process, the following message will be displayed:

FW updated successfully!

Welcome to the Dell 10GbE PTM Management Console firmware X.X.XXX-<date stamp>

Figure 13: Transferring the .pfw File

Software User's Manual