Dell PowerSwitch S4148U-ON Manuel d'installation - Page 39

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerSwitch S4148U-ON. Dell PowerSwitch S4148U-ON 49 pages.

Imprimer la page

USB-B console port access

The USB-B console port is on the I/O side of the switch.

NOTE:

The S4100-ON Series switches use the Silicon Labs CP2109 USB-B chip. To find the correct USB-B universal

asynchronous receiver-transmitter (UART) driver, see

usb-to-uart-bridge-vcp-drivers.

The terminal settings are the same for the serial console port and the RS-232/RJ-45 console port:

● 115200-baud rate

● No parity

● Eight data bits

● One stop bit

● No flow control

When you connect the USB-B port, it becomes the primary connection and, while connected, all messages are sent to the

USB-B port.

NOTE:

Before starting this procedure, be sure that you have a terminal emulation program that is already installed on your

personal computer. Install the appropriate drivers to support the USB-B port. To download Dell drivers, see

support. If your system requires non-Dell drivers, contact Dell Technical Support for assistance.

To access the USB-B console port:

1. Power on the personal computer.

2. Connect the USB-A end of cable into an available USB port on the personal computer.

3. Connect the USB-B end of cable into the USB-B console port on the S4100-ON Series switch.

4. Power on the S4100-ON Series switch.

5. Install the necessary USB device drivers.

To download Dell drivers, see www.dell.com/support. If your system requires non-Dell drivers, contact Dell Technical

Support for assistance.

6. Open your terminal software emulation program to access the S4100-ON Series switch.

7. Confirm that the terminal settings on your terminal software emulation program are as follows:

● 115200-baud rate

● No parity

● Eight data bits

● One stop bit

● No flow control

USB storage

USB storage does not automatically mount. The supported file system is FAT. To use USB storage, first mount the device using

the following steps:

1. Create a mount directory for the USB.

ONIE:/ # mkdir /mnt/usb

2. View the fixed disks using fdisk.

ONIE:/mnt # fdisk -l

For internal storage:

Disk /dev/sda: 15.8 GB, 15829303296 bytes

255 heads, 63 sectors/track, 1924 cylinders

Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot

/dev/sda1

Start

End

1925

https://www.silabs.com/products/development-tools/software/

Blocks

Id System

15458303+ ee EFI GPT

www.dell.com/

Management ports