Dell S4048-ON Manuel de configuration - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Dell S4048-ON. Dell S4048-ON 30 pages. Enterprise switches
Également pour Dell S4048-ON : Manuel de configuration (19 pages), Manuel de dépannage (29 pages)

Imprimer la page

Switch configuration (OS 10.x)

3.1.13

Save configuration

OS10#copy running-configuration startup-configuration

OS10#reload

System configuration has been modified. Save? [yes/no]: yes

Proceed to reboot the system? [confirm yes/no]:yes

3.1.14

Configure additional switch

Repeat the commands from section 3.1 to configure the second switch.

Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a

non-default VLAN, refer to the switch documentation.

3.2

Configure Data Center Bridging (DCB) (optional)

To enable DCB mode on the switch, use the following commands.

Note: You must complete the Dell EMC recommended switch configuration steps in section 3.1 before

configuring the switch for DCB mode.

3.2.1

Disable iSCSI

OS10# configure terminal

OS10(config)# no iscsi enable

OS10(config)# no iscsi session-monitoring enable

3.2.2

Disable 802.3x flowcontrol on all ports

OS10(config)# interface range ethernet 1/1/1–1/1/48

OS10(conf-range-eth1/1/1-1/1/48)# no flowcontrol receive

OS10(conf-range-eth1/1/1-1/1/48)# no flowcontrol transmit

OS10(conf-range-eth1/1/1-1/1/48)# exit

OS10(config)#

3.2.3

Enable DCB

OS10(config)# dcbx enable

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026