Dell S4148-ON Manuel de configuration - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Dell S4148-ON. Dell S4148-ON 19 pages. Dell emc sc series sans

Imprimer la page

Dell EMC recommended switch configuration

The steps in this section show how to configure two Dell EMC Networking S4148-ON/S4128-ON switches in

Dell SC series storage environment.

Note: The configuration steps in this section are only recommended when the switch is used as a dedicated

SAN for iSCSI traffic.

2.1

Hardware configuration

1. Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using PuTTY or another terminal utility, open a serial connection session to the switch.

4. Open the terminal emulator and configure it to use the serial port (COM1, COM2). Configure serial

communications for 115200 N,8,1 and no flow control.

Note: This example assumes a switch at its default configuration settings. Always back up the configuration

settings prior to performing any configuration changes.

2.1

Check firmware version

OS10# show version

Note: If the active version displayed here is not 10.3.1.x or later, visit

latest update for the switches.

2.2

Delete startup configuration

Note: The following commands will delete all configuration settings.

OS10# delete startup-configuration

Proceed to delete startup-config [confirm yes/no(default)]yes

OS10# reload

System configuration has been modified. Save? [yes/no]no

Proceed to reboot the system? [confirm yes/no]yes

Note: The switch will reboot. After the startup configuration is deleted, the factory default password is admin.

7 Dell EMC Networking S4148-ON and S4128-ON Switch Configuration Guide for Dell EMC SC Series SANs | SCG3704

Dell.com/support

and download the