Entec Solar E-1000 Manuel de démarrage rapide - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Entec Solar E-1000. Entec Solar E-1000 17 pages.

6. Adjust date and time, and synchronize with the E-Sens. Select Settings -> Other

->Adjust Date/Time (Section 5.5.11A)

IMPORTANT: Before starting with a new season of measurements, make sure

that the conﬁguration values of the device are properly set up and that they match

the circuit under test.

IMPORTANT: It is mandatory to introduce the values on all the empty gaps,

even if they are zeros.

7. Set up the characteristic module under test (VOC, ISC, VM, IM, α, β y NS).

Settings-> Module Settings (Section 5.5.4). Save the conﬁguration in a memory

slot for modules (Section 5.5.4.B).

8. Set up the generator settings (number of modules on series and parallel). Settings

-> Generator settings (Section 5.5.5).

9. Verify the radiance sensor calibration (reference cell) Settings -> Sensor settings

(Section 5.5.6.A).

10. Select E-Temp or PT1000 depending on the temperature sensor you want to

use. You can do this on the main screen or inside the sensor settings menu. (Section

5.5.6.B).

11. Set up the tolerance threshold. For Isc, Voc y Pm. Settings -> Other ->

Tolerance. (Section 5.5.11.C)

12. Select the ﬁle name to store the data. (Section 5.2.2.E)

13. Select and set up the measurement options (manual measurement, auto

measure,continuous measurement). (Section 5.5.7 5.5.9)

14. Select the saving options (manual save or autosave). (Section 5.5.8)

5.2 Conections set up

Reference cell

The radiance sensor is a calibrated solar cell made out of silicon, that need to be

placed on the same plane as the solar module. It is connected with the E-Sens with

some banana plugs to measure ISC on the 2V connector located on the lower right

part of the device. Additionally, you may connect the PT-1000 of the reference cell

to correct radiance using the temperature measurement of the calibrated cell. These

banana plugs are connected on the lower left side of the device.

"Innovative technological developments for the solar photovoltaic industry"