EarthQuake Cinenova Grande BR 5 Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} EarthQuake Cinenova Grande BR 5. EarthQuake Cinenova Grande BR 5 20 pages.

EarthQuake Cinenova Grande BR 5 Manuel de l'utilisateur
Cinénova Grande BR Pre-Setup
Getting Started with the Cinénova Grande BR
Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the
circuit breaker for this information.
Amplification Block Plate
1
2
3
8
Power Plate
4
6
5
1) INPUT SELECTION
Set the input control to either RCA or XLR.
This tells the amp which input type will be
used.
3) SPEAKER CONNECTIONS
A pair of binding posts is
p r o v i d e d f o r e a c h
channel. These posts
accept bare wire, spade
lugs & banana type
plugs. If bare wire is
u s e d t h e n , s t r i p
approximately 1/2 inch
to 3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert.
5) PLUG IN POWER CORD
Plug the AC power cord
into the amp first then
into the wall outlet.
Make sure it is firmly
connected.
specifications are subject to change without notice
Earthquake Sound
2) X-OVER MODE SELECTION
The Cinénova Grande houses 5 or 7
amplification blocks. Each block comes with a
3-way Mode Selection switch. Generally the
amplifier Is used in By Pass mode and fed a
crossed signal from a processor. Unless
otherwise desired, the crossover switch
should remain in Bypass position.
4) 12VDC
WHEN APPLICABLE
If you plan to power the
Cinénova using an
external source, then
you will need to plug the
source into the 12VDC
Trigger.
When using this feature
the main power switch
must remain in the OFF
position at all times.
6) TURN ON CIRCUIT BREAKER
This amp is equipped
with a 20 ampere circuit
breaker. Once that all
tasks have completed
then proceed to turn the
circuit breaker to the on
position.