EarthQuake PH2000W/D1.1 Manuel du propriétaire - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} EarthQuake PH2000W/D1.1. EarthQuake PH2000W/D1.1 10 pages. Powerhouse series amplifiers
Également pour EarthQuake PH2000W/D1.1 : Brochure (8 pages), Manuel du propriétaire (11 pages), Manuel du propriétaire (10 pages)
Imprimer la page
PH2200W/4
Remote ON Auto ON
Signal Sensor:
Four RCA level inputs
Remote ON/Auto
crossed outputs, can be
ON feature (see
used to feed other
page 5).
amplifiers in the system
Speaker
To car chassis / ground
Outputs
To remote turn on / trigger
Minimum
4 Ohm
To battery (+)
Mono
10
Specifications Are Subject To Change Without Notice
3-way switch feeds, RCA outputs
3/4 a full range, high-pass or low-
pass signal.
3-way
switch
for each block
runs CH1/2 or CH3/4 in low
-pass, full-range or high-
pass mode.
Tonal controls CH3/4:
+ 12dB boost @ 12kHz
+ 18dB boost @ 45Hz
Four RCA level inputs
with a range of 0.2V to
5V. RMS.
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
GND
REM
BAT
POWER
Two 30A Fuses
Set Xover knob to
Minimum (20Hz), &
set Xover switch to
by-pass, (full-range)
FC6.2 Midrange
FC6.2 Midrange
FC6.2
FC6.2
Tweeter
Tweeter
FC6.2 Midrange
FC6.2 Midrange
FC6.2
FC6.2
Tweeter
Tweeter
www.earthquakesound.com
11