EarthQuake 9000E Manuel de l'opérateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} EarthQuake 9000E. EarthQuake 9000E 12 pages. Power earth auger
Également pour EarthQuake 9000E : Manuel de l'opérateur (12 pages)

Imprimer la page

MAINTENANCE AND ST

MAINTENANCE AND ST ORAGE

MAINTENANCE AND ST

CAUTION

To prevent accidental starting:

Engine must be turned off and cool, and spark plug wire

must be removed from spark plug before checking and

adjusting engine or equipment.

CAUTION

Temperature of muffler and nearby areas may exceed

150° F (65° C). Avoid these areas.

CAUTION

Check auger often for loose nuts and bolts. Keep these

items tightened.

MAINTENANCE AND ST

MAINTENANCE AND STORAGE SAFETY

MAINTENANCE AND ST

1. Always allow muffler to cool before filling fuel tank.

2. When storing for over 1 month, use gas stabilizer in

fuel.

3. Keep all screws, nuts, and bolts tight.

4. Close fuel shut-off valve located between gas tank and

carburetor.

5. Do not fill gas tank indoors or when engine is running

or is hot.

6. The gear case has 4 oz. of grease installed at the

factory. It is recommended that once a year the gear

case be split and the grease level checked. Add grease

only if level of grease is below top of the gears. DO

NOT OVERFILL.

7. For cold weather operation, store the unit in a cool

environment. Transferring the unit from a warm to a

cold place can cause the build up of harmful

condensation.

ORAGE

ORAGE SAFETY

ENGINE MAINTENANCE

Do not operate auger before reading the engine manual

provided in the parts packet.

Engine can overheat and become damaged if debris blocks

the cooling fins or recoil housing.

Refer to the engine manual included in your parts packet

for information on engine maintenance. Your engine

manual provides detailed information and a maintenance

schedule for performing the following tasks:

1. Check air cleaner. See engine manual for instructions.

2. Keep engine and parts clean. See engine manual for

instructions on cleaning recoil housing area, linkage,

springs and controls, muffler area, cooling fins, and

spark plug.

ST ST ST ST STORAGE

ORAGE

Do not store auger in an unventilated area where fuel

fumes may reach an open flame, spark or pilot light.

Drain fuel outdoors, away from any ignition sources. Use

only approved fuel containers. Be sure engine is cool. Do

not smoke.

Follow the steps below to prepare your auger for storage.

Read your engine manual for detailed instructions on

preparing the engine for storage.

1. Run with gas stabilizer in fuel. Screen in carburetor will

glaze shut if gas stabilizer is not used before storage.

2. Drain the fuel tank. Run the engine until it stops.

3. Remove spark plug, pour one-half ounce of clean

engine oil into cylinder. Pull starter handle slowly

several times to distribute oil. Replace spark plug.

4. Clean entire auger.

5. Store your auger in a clean, dry building that is

inaccessible to children.

Page 5

CAUTION

ARDISAM