EarthQuake 9800B Manuel d'utilisation et de pièces - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et de pièces pour {nom_de_la_catégorie} EarthQuake 9800B. EarthQuake 9800B 13 pages. Two-man earth auger powerhead
Également pour EarthQuake 9800B : Manuel de l'opérateur (20 pages)

Imprimer la page

EarthQuake 9800B Manuel d'utilisation et de pièces

OPERATION

REGISTRATION FORM

REGISTRA

TION FORM

REGISTRA

TION FORM

Complete and return. Your powerhead has a model/

serial number decal located on the muffler side of the

engine. Record this number and the model number in the

space provided on page 2 of this manual. You will need

these numbers if you order parts. Fill out and mail the

registration card located in your parts packet. Warranty is

valid only if your completed registration card is received

by Ardisam, Inc., at time of purchase.

SP SP SP SP SPARK PL

ARK PL

UG INST

ALLA

ARK PLUG INST

ARK PL

UG INST

UG INSTALLA

ALLATION

ALLA

If your powerhead does not have the spark plug already

installed for you. You will have to install it following the

instructions given below.

1. Locate the spark plug in the parts packet.

2. With powerhead laying on side labeled "THIS SIDE

UP WHEN NOT IN USE," place spark plug in spark plug

hole. For replacement use Champion RC-12YC only.

NOTE: A resistor spark plug must be used for

replacement.

3. Turn by hand until snug.

4. Use a wrench or socket to tighten to 180 inch-pounds

of torque. DO NOT OVERTIGHTEN.

Page 4

TION

OPERA

OPERATION

OPERA

TION

OPERA

TION

CAUTION

Please do not start your earth auger unit until you

have read the Engine Manual that came with your

engine, and the section in this manual titled Safety.

If you have read these, follow the steps below to

start your earth auger unit. Always perform pre-

start checklist before starting the engine.

1. Read engine manual and follow instructions for fuel

type, starting, etc.

2. The clutch will transfer maximum power after about

two hours of normal operation. During this break-in

period clutch slippage may occur. The clutch should be

kept free of oil or other moisture for efficient operation.

Each powerhead is tested at the factory, but is not

operated for the full break-in period.

3. The earth auger unit should be operated no more than

20 degrees in any direction during continuous use and

limited to 30 degrees intermittently. Recommended for

adequate lubrication and fuel delivery.

CAUTION

It is recommended that the earth auger unit not

be tilted at more than a 30 degree angle from the

upright position. Failure to do so can cause fuel

and/or oil leakage.

4. When digging in heavy soil, pump the earth auger unit

with an up and down motion in the hole for every one foot

of depth.

5. Never run engine indoors. Exhaust fumes are deadly.

6. Do not use an earth auger in ice.

ARDISAM

.com

800-345-6007