Award H290/1S Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Award H290/1S. Award H290/1S 16 pages.
Imprimer la page
•
2. INSTALLATION AND
PREPARATION FOR USE
WARNING : This hob must be installed
by an authorised service person or qualified
technician, according to the instructions in
this guide and in compliance with the current
local regulations.
Incorrect installation may cause harm
•
and damage, for which the manufacturer
accepts no responsibility and the
warranty will not be valid.
•
Prior to installation, ensure that the local
distribution conditions (electricity voltage
and frequency and the adjustments of
the hob are compatible. The adjustment
conditions for this hob are stated on the
label.
The laws, ordinances, directives and
•
standards in force in the country of use
are to be followed (safety regulations,
proper recycling in accordance with the
regulations, etc.).
2.1 Instructions for the Installer
General instructions
•
After removing the packaging material
from the hob and its accessories,
ensure that the hob is not damaged. If
you suspect any damage, do not use it
and contact an authorised service
person or qualified technician
immediately.
Make sure that there are no flammable
•
or combustible materials in the close
vicinity, such as curtains, oil, cloth etc.
which may catch fire.
The worktop and jioinery surrounding
•
the hob must be made of materials
resistant to temperatures above 100°C.
If a range hood or cupboard is to be
•
installed above the hob, the safety
distance between hob and any joinery/
range hood should be as shown below.
Minimum
42 cm
•
The hob should not be installed directly
above a dishwasher, fridge, freezer,
washing machine or clothes dryer.
•
If the base of the hob is accessible by
hand, a barrier made from a suitable
material must be fitted below the base of
the hob, ensuring
to the base of the hob.
2.2 Installation of the Hob
The hob is supplied with an installation
kit including adhesive sealing material,
fixing brackets and screws.
•
Cut the aperture dimensions as
indicated in the figure. Locate the
aperture on the worktop so that, after
the hob is installed, the following
requirements are followed.
B (mm)
290
T (mm)
520
H (mm)
47.5
C1 (mm)
270
C2 (mm)
490
D (mm)
50
J (mm)
5
EN - 8
Minimum
42 cm
HOB
that there is no access
min. A (mm)
50
min. C (mm)
50
min. E (mm)
250
min. F (mm)
10
G (mm)
20
I (mm)
25