EarthWay 2170 Manuel d'assemblage et d'utilisation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage et d'utilisation pour {nom_de_la_catégorie} EarthWay 2170. EarthWay 2170 6 pages. Commercial broadcast spreader with side spread control
Également pour EarthWay 2170 : Manuel d'assemblage et d'utilisation (6 pages), Manuel d'assemblage et d'utilisation (8 pages), Manuel d'utilisation (8 pages), Manuel d'instructions de montage (12 pages), Manuel d'instructions de montage (10 pages)

Imprimer la page
EarthWay 2170 Manuel d'assemblage et d'utilisation
Pinion
Shaft
Impeller
Cross Brace
Gearbox Brace
COAST WHEEL
HOLE
Gearbox & Axle Assembly
3. Install impeller onto pinion shaft. Insert 1/8"x 1¼" cotter pin
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out. Next insert
Cross Brace thru the Gearbox Brace as shown above.
Axle Bearing
Flat
Side
5. Install axle bearings to both lower handles.
NOTE: Notch on bearings and lower
handles. Bearings must go through flat side
of lower handle.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP.
PAGE 2
1/8 x 1-1/4"
Cotter Pin (#36105)
DRIVE WHEEL
HOLE
Notch
Coast wheel side
1/4-20 x 1-1/2"
Hex Head Bolt
Step 6B
Step 6C
1/4-20 x 2-1/4"
Hex Head Bolt
Step 6A
6. A - Install lower handles onto axle to both sides as shown. Insert 2¼" bolt through second
hole in lower handle and through first hole in frame install locknut. DO NOT TIGHTEN.
B - Now insert 1½" bolt through first hole in lower handle. Then through frame brace.
NOTE: Dimples on frame brace must be facing toward gear box as shown. Next into threaded
connector in cross brace. DO NOT TIGHTEN.
C - Next insert 1½" bolt through other end of frame brace and through second hole in frame
install locknut.
DO NOT OVER TIGHTEN.
4. Install gear box by inserting the pinion shaft into hole in
center of hoppers bottom. The word "FRONT" on the gearbox
must point to Front of the hopper. Follow label instructions on
hopper.
Gearbox & Axle Assembly
Cross Brace
Impeller
Shut-Off
1/4-20 Locknut
Pivot Rod
Drive wheel side
Frame brace
Dimples
Frame
1/4-20 x 1-1/2"
Pan Head Bolt
Lower Handle