EarthWay SPRAY-PRO S15 Instructions de montage et d'utilisation

Parcourez en ligne ou téléchargez le pdf Instructions de montage et d'utilisation pour {nom_de_la_catégorie} EarthWay SPRAY-PRO S15. EarthWay SPRAY-PRO S15 5 pages. Push sprayer

Imprimer la page

S15

SPRAY-PRO

ASSEMBLY and OPERATING INSTRUCTIONS

Congratulations on the purchase of this new sprayer from Earthway Products, Inc. Please call us if you have any difficulty

with assembly or operation of this sprayer. We can be reached via the telephone at 800-294-0671 or 574-848-7491,

Monday—Friday 9:00am ~ 4:00pm or visit us online at www.earthway.com This sprayer comes with lifetime technical

support, email us at [email protected].

HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY

THIS SPRAYER COMES FULLY ASSEMBLED, REQUIRING YOU TO FLIP UP THE HANDLE AND TIGHTEN TWO WING

NUTS - NO TOOLS REQUIRED.

Your sprayer is designed to be pushed at two to three miles per hour, which is a brisk walking speed. Slower or faster

speeds will change the spray patterns and output volumes.

Clean your sprayer tank thoroughly after each use. Wash with clean water and push sprayer a several feet to evacuate

any residual materials until you see clean water in a safe area as described in the chemical suppliers directions.

Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.

Check all hose connections regularly to ensure they remain tight.

If unit fails to spray on initial use see Initial Start-Up Procedures on page 3.

To help prevent corrosion, coat all metal surfaces (inside & out) with WD-40 or a light oil.

When the tank is empty, pull the sprayer backward to the designated cleaning or storage area to prevent damage that

can occur with a dry pump.

ASSEMBLY INSTRUCTIONS

Open carton and remove the S15 from carton.

Place the S15 onto its wheels.

Loosen the two wing nuts that secure the handle slightly.

Lift the handle into place and tighten the two wing nuts.

Now you are ready to go!

DO NOT PUSH

FORWARD WITH TANK

EMPTY

For best results keep enough

of the liquid in the tank to

keep the pump supply line

filled. Hills and rough ground

can create a "wave effect" in

the tank that will cause the

pump to have an inconsistent

spray or to lose prime. If

this occurs, turn the control

lever to TRANSPORT and

push a few feet to re-establish

the prime and continue from

where you stopped.

PUSH SPRAYER

Earth Way

SPRAY-PRO

Lift the handle

and tighten the

wing nuts to lock the

handle in place.

3-2012 Pt.# 52238

PAGE 1