Award Session JD10 MK2.3 Mode d'emploi

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} Award Session JD10 MK2.3. Award Session JD10 MK2.3 3 pages. Direct recording preamp

Imprimer la page

Additional Information

XLR Output Pin Connections - The signal appearing in PIN 2 is IN PHASE with the signal appearing on

the TIP contact of the JACK output.

PIN 2 - Hot/Signal

Note to our American customers:

The JD10 you have just bought is an updated version of the JD10 formerly available under the MORLEY

brand. The differences are: New distortion circuitry, a balanced volume level between Classic & Rock gain

settings, silent FET switching, a male XLR output connector and new artwork to the facia.

Stewart Ward

AP10/GG10/JD10 Designer.

This manual applies only to: JD10 MK2.3 - PCB Issue: 07011H - 18/11/2004 or later.

Hand assembled in England By:

Award-Session, 34 Belvedere, Basingstoke, Hampshire, RG24 8GB, UK

Tel. +44 (0)1256 477 222 - Email. [email protected]

Website: www.award-session.com

PLEASE READ THIS BEFORE CONTACTING US!

Male XLR Output - The XLR chassis plug

provided will mate with any standard microphone

cable wired for 'balanced' signals. The signal

available is an un-balanced signal, but is equal in

quality to that of a balanced line. It is identical to

to that appearing on the JACK output, tip

connection - so there is no difference or benefit to

using one output over the other, except that of

convenience.

PIN 3 - Ground

PIN 1 - Ground

JD10

MK2.3

T T h h e e B B r r i i t t i i s s h h B B o o u u t t i i q q u u e e P P e e d d a a l l

The British Boutique Pedal

Operating Instructions

Direct Recording PreAmp