ALLIGATOR sens.it RetroFIT-kit 2.0 Manuel d'utilisation - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} ALLIGATOR sens.it RetroFIT-kit 2.0. ALLIGATOR sens.it RetroFIT-kit 2.0 18 pages. Pressure monitoring system
Imprimer la page- The pre-decimal position of the pressure display begins to blink after you briefly press
Bt1.
- Now press Bt2 repeatedly until the pre-decimal position has reached the selected limit
value.
- Now press Bt1 again to select to decimal place.
- Now press Bt2 repeatedly to adjust the selected limit value for the decimal place.
- Press Bt1 to confirm the entry.
- Now proceed analogously for the rear axle (as described above).
1.12 Learning
Step 5 Learning process for sensor replacement
e.g. in case of wheel replacement
- Press and hold Bt1 to enter the settings.
- Press Bt1 repeatedly until "ID" is displayed at all four positions
17
- Press Bt2 and the display "ID" appears for the front left with an arrow pointing down (
).
- Hold the display near the front left wheel and release air until the arrow pointing down
disappears. Open (press) the valve insert to release air (see Figure 17)
- Then an arrow pointing up appears (
normal fill pressure (pressure setpoint) indicated in the vehicle owner's manual.
- Repeat the process in anticlockwise motion for the remaining tyres
1. FL = front left
2. RL = rear left
3. RR = rear right
4. FR = front right
). If this is the case, fill the tyre to the specified
15