ALLIGATOR sens.it RetroFIT-kit 2.0 Manuel d'utilisation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} ALLIGATOR sens.it RetroFIT-kit 2.0. ALLIGATOR sens.it RetroFIT-kit 2.0 18 pages. Pressure monitoring system
Display operation
1.6 Switch-on process
Briefly pressing Bt1 or Bt2 switches on the display.
The display is then in the initial learning mode or monitoring mode. Monitoring mode is
recognisable by the clockwise-rotating arrow.
Attention! Switch on the display before each drive, because it only provides warnings
when switched on.
1.7 Initial learning process
Requirement:
All 4 sensors have been mounted in the appropriate tyres and each has been mounted in
the correct position on the vehicle as shown in Figure 15.
Attention! For the initial learning process, the display must be in its condition as supplied.
(No sensors have been learned in the display)
This is recognisable by the blinking of all four positions on the CAL display.
If the display learning process has already taken place, please proceed with the steps in
chapter 1.12
Learning:
For the learning process, please drive for at least 10 minutes at a speed in excess of 20
km/h.
Example:
CAL=calibration (learning mode)
Pressure values are received
Received sensor pressure values are
displayed
9