Miele W 6071 Instructions d'utilisation et d'installation - Page 39
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Miele W 6071. Miele W 6071 44 pages.
Également pour Miele W 6071 : Manuel d'utilisation (40 pages), Manuel d'utilisation (38 pages)
Imprimer la page
Please read the installation diagram and
instructions supplied. They are important
for the proper connection of supplies.
Water connection
The water hook up is by a water valve, which
conforms with local and national regulations.
This work must be carried out by a Miele
authorized service technician.
The inlet pressure hoses supplied with the
machine must be used for connection to the
water supply.
To ensure the hot water inlet hose (marked
194°F/90°C) lasts for many years, do not
hook the hose up to a hot water connection
supplying water hotter than 158°F (70°C).
This hose should only be replaced with a
genuine Miele spare parts.
A water pressure flow rate of 30 psi - 145 psi
(2 -10 bar) is required.
Water taken into the machine must not
exceed a temperature of 158°F (70°C).
Connection to cold water only:
see, the supplied installation diagram.
Drainage system
Possible connections:
1. Directly into a sink: hook the hose over
the edge of the sink and secure it firmly
(e.g. by tying the hose to the water
faucet.)
2. To a stand pipe: place the drain hose into
a 1
½
" stand pipe and firmly secure it.
3. To a floor drain: The machine is
equipped with an air gap/anti-siphoning
system so that no minimum drain height
is required.
– The machine drains using a pump with a
maximum delivery height of 3 ft.
– The elbow on the end of the drain hose
can be turned or removed if necessary.
– Make sure there are no kinks in the drain
hose.
– If desired, the drain hose may be
extended to run 16 ft maximum as long as
the 3 ft height is not exceeded. Hose
extensions are available from your dealer
or Miele's Technical Service Department.
Plumbing
39