Miele W 6073 Manuel d'utilisation - Page 29
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Miele W 6073. Miele W 6073 34 pages.
Également pour Miele W 6073 : Manuel d'utilisation (34 pages)
Imprimer la page
The washer-extractor must be installed
and commissioned by an approved Cus-
tomer Service technician or authorised
Service Dealer.
Installation
A concrete floor is the most suitable installa-
tion surface. Please note:
^ The machine must be level and securely
positioned.
^ Do not install the machine on a 'soft' base
such as floorboards as this could result in
more vibration during the spin cycles.
^ If the machine is installed on a raised
plinth it should be secured using the butt
straps supplied with the machine.
If there is not already a concrete plinth
on-site, the Miele Spare Parts department of-
fer a steel plinth. The steel plinth must be se-
cured to the floor, (see the enclosed installa-
tion plan).
To avoid the possibility of frost damage on
no account install the machine in a room
which is exposed to frost.
Transit fittings
When the machine has been installed in its
final position, only then remove the red tran-
sit fittings marked "A", "B". and "C".
M.-Nr. 06 006 810
Notes for the installer
Front transit fitting
The front panel must be taken off, (2 internal
torx T20 screws at the bottom) in order to re-
move the front transit fitting (3 SW-13
screws).
Rear transit fitting
"B" (1 piece)
The rear panel must be taken off, (just
loosen 15 internal torx T20 screws at the bot-
tom) in order to remove the rear transit fitting
(3 SW13 screws each).
The machine must not be moved without the
transit fittings in place.
"A" (1 piece)
"C" (1 piece)
29