Miele W 820 Manuel d'utilisation - Page 36

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Miele W 820. Miele W 820 40 pages. Novotronic
Également pour Miele W 820 : Manuel d'utilisation (41 pages)

Imprimer la page

Plumbing

Connection to water supply

The machine should be connected to a

mains water supply in accordance with

standard regulations. The German auth-

orities do not require it to have a non-re-

turn valve as the washing machine has

been designed to comply with DVGW

regulations (German Association of

Gas and Water Engineers, see data

plate).

Connection to a mains water supply

should be carried out by a qualified

plumber and should incorporate a

mains stopcock with 3/4" thread

The 1.5 m long 3/8" pressure hose

should be connected to the stopcock

via the 3/4" threaded union.

This hose is not suitable for use for con-

nection to a hot water supply. Please

make sure that the washer sits correctly

in the union.

All manuals and user guides at all-guides.com

If connection is to be made to a stop-

cock with a short 3/4" thread, the extra

washers enclosed should also be in-

serted in the inlet hose union to com-

pensate.

The connection points are subject to

mains water pressure. Turn on the stop-

cock slowly and check for leaks. Cor-

rect the positioning of the washers and

screw unions if appropriate.

If replacing the inlet hose only use a

hose able to withstand pressure of up

to 70 bar. This also applies to all fittings

used. Miele original parts fulfil this con-

dition.

Longer hoses 2.5 or 4.0 m in length are

available as optional extras.

The pressure hose and solenoid inlet

valve are designed for a water flow-

pressures of between 1 and 10 bar

(981 kilonewtons/m

). At higher water

pressures it is essential to fit a reducer

valve.

There is a minimum flow pressure of 1

bar pressure if 5 litres of water flow into

a suitable container in 15 seconds.

The two dirt filters, one at the inlet

point, one in the pressure hose

union, must not be removed.

Caring for the environment

Caring for the environment means sav-

ing water, energy and detergent when

washing. This machine is equipped

with the Hydromatic System and the

Ball Valve for economical use of re-

sources. These systems offer a variety

of technical innovations e.g. the drum

ribs, which are designed to enable

economical washing without compromi-

sing on results.

The automatic load control facility en-

ables loads of between 1 and 5 kg to

be washed using only as much water

and electricity as is required for an ef-

fective wash.

Spinning at the high speed of

1200 rpm reduces drying times and en-

ergy consumption if laundry is dried in

a tumble dryer after washing.

Caring for the environment

Economy tips

To help you wash most economically,

remember the following tips:

Always wash with the maximum

laundry load specified for each pro-

gramme. This uses the energy to the

best advantage.

Only use the correct amount of deter-

gent required for the water hardness

level in your area, as recommended

by the manufacturer.

If laundry is not heavily stained, se-

lect a lower temperature setting than

indicated on the laundry care label

(but when using a lower temperature

do not select the "short"-option).

Lightly soiled laundry can be

washed using a "short"-programme

(additional temperature reduction

not recommended).