Allmand Night-Lite E Series Manuel de l'opérateur - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Allmand Night-Lite E Series. Allmand Night-Lite E Series 20 pages. Portable light tower

Imprimer la page

Figure 7

5. Repeat for the remaining outriggers

and stabilizer jacks.

6. Level the portable light tower front to

back and side to side with the jacks,

using the level as a guide.

To stow the jacks and outriggers:

1. Make sure that the lights are shut

down and the light tower mast is

completely lowered.

WARNING

Tipover Hazard

Failure to lower the light tower mast

before stowing the outriggers could

cause the light tower to tip over, result-

ing in death or serious injury. Always

lower the light tower mast before stow-

ing the outriggers.

2 Fully raise the stabilizer jack foot by

turning the jack handle clockwise.

3. Fold the handle.

4. Remove the stabilizer jack locking

pin, rotate the jack into the transport

position, and install the stabilizer jack

locking pin fully through the top and

bottom holes in the jack and outrig-

ger.

5. Remove the hair pin cotter and outrig-

ger locking pin. Raise the outrigger

into the transport position, and lock in

the transport position with the outrig-

ger locking pin. Secure with the hair

pin cotter.

6. Repeat for the remaining stabilizer

jacks and outriggers.

Preparing To Operate The Unit

Follow these steps to prepare the por-

table light tower for operation:

1. Level the portable light tower. See

Leveling And Stabilizing The

Portable Light Tower.

2. Connect a heavy-duty, exterior-

use power cord (15 amp) from the

power outlet on the side of the unit

(A, Figure 8) to a 120-volt AC power

source. See Specifications.

Figure 8

Portable Light Tower

Operation

Adjusting The Lights

WARNING

Burn Hazard

• Adjusting the lights while illuminated

could result in death or serious inju-

ry. Always adjust the lights with the

unit shut down.