360 Yield 360 Y-DROP CASE 120 BOOM Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 360 Yield 360 Y-DROP CASE 120 BOOM. 360 Yield 360 Y-DROP CASE 120 BOOM 10 pages.

Imprimer la page

INSTALL BREAKAWAY ASSEMBLY -

ONE PIECE

Figure 14

Step 1

Install breakaway assembly - one piece (1)

using the square U-bolts (2) and the extra

thick washer and Nylock nut. Repeat for

the remaining breakaway assemblies -

one piece.

Hardware Kit C

Figure 15

Figure 15 may show more or fewer mounts than

your installation. The alignment and quantity of the

mounts will depend on your row spacing.

Figure 16

Step 2

Install riser tube assembly (1) into the

breakaway assembly - one piece (2).

Step 3

Install pin (3).

Repeat Steps 2 and 3 for the remaining riser tube

assemblies.

NOTE: Included in most sprayer mount packages

are standard riser mounts to be used when primary

booms are folded and in transport mode. These

standard riser mounts should be mounted in

locations that allow you to relocate the drops away

from potential tire interference. See "Install Riser

Mounts Without Breakaway Assemblies" section on

next page for more instructions.

INSTRUCTIONS 360 Y-DROP

Figure 14

Figure 15

Figure 16

CASE 120' BOOM

360YIELDCENTER.COM