Miele DA 216-2 Instructions d'utilisation et d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Miele DA 216-2. Miele DA 216-2 40 pages. Miele operating and installation instructions cooker hoods da 216-2, da 216-2 ext, da 217-2, da 219-2, da 219-2 ext

Imprimer la page

When using the cooker hood in

extraction mode at the same time

as another heating appliance which de-

pends on the air in the room, (e.g. gas,

oil or coal fired heaters, continuous flow

or other water heaters, gas cooker, gas

hob or gas oven) special care must be

taken, as the action of the cooker hood

extracts air from the room, which these

types of heater need for combustion.

They could also draw exhaust air back

in from chimneys or ducting in con-

travention of fire safety regulations.

In order to ensure safe operation, and to

prevent gases given off by the heating

appliances from being drawn back into

the room when the extractor and the

heater are in operation simultaneously,

an underpressure in the room of 0.04

mbar (4 pa) is the maximum permissible.

Ventilation can be maintained by air in-

lets which cannot be blocked, in win-

dows, doors and outside wall vents, or

by other technical measures, such as

ensuring that the extractor can only be

switched on when the heating ap-

pliance is switched off or vice-versa.

N.B: The overall ventilation condition of

the dwelling must be taken into ac-

count. If in any doubt, the advice of a

competent builder or, for gas, a "Corgi"

installer must be sought.

If the cooker hood is operated in recir-

culation mode (with active charcoal

filter) then the above restrictions do not

apply.

For appliances with an external fan

motor fitted (EXT models) the con-

nection of the two units must be made

using the connection cable and the

plug connectors. Make sure the correct

combination of the two appliances has

been selected.

Separate instructions are supplied with

the external fan.

Before discarding an old ap-

pliance, switch off and disconnect

it from the power supply. Cut off and

render any plug useless. Cut off the

cable directly behind the appliance to

prevent misuse.

This should be done by a competent

person.

The manufacturer cannot be held

liable for damage caused by non-

compliance with these Warning and

Safety instructions.