Miele DA 239-3 Instructions d'utilisation et d'installation - Page 24

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Miele DA 239-3. Miele DA 239-3 40 pages. Ventilation system
Également pour Miele DA 239-3 : Instructions d'utilisation et d'installation (40 pages)

Imprimer la page

The majority of the weight of the

installed Ventilation System will be

supported by the motor assembly.

Its mounting bracket must be firmly

attached to the stud framing behind

the drywall. If studs are not located

in the required locations, a plywood

backing (min.

spanning at least two studs must be

installed. Failure to adequately

support the weight as stated may

result in the Ventilation System falling

off the wall causing injury and

property damage.

(If plywood backing is not needed,

proceed to "Attaching the hood and

motor assembly to the wall.")

^ Determine and mark the location of

the motor assembly as outlined in

"Attaching the hood and motor

assembly to the wall."

^ Mark a horizontal line 3" (76 mm)

above and 9" (229 mm) below the

mounting screw locations.

" (13mm) thick)

^ Find the studs to the left and right of

the mounting location by tapping the

wall or using a stud finder.

^ Mark the center of each of the studs

with a vertical line.

Be careful not to damage any wiring

or plumbing that may be located

behind the wall. Make sure that the

power supply to the area being

worked in has been turned off at the

breaker panel before cutting into the

wall.

^ Cut out the drywall along the marked

lines and replace it with plywood of a

matching thickness (min.

thick). Tape the joints and refinish the

wall.

^ To complete the installation proceed

to "Attaching the hood and motor

assembly to the wall."

" (13 mm)