Miele DA 2390 Instructions d'utilisation et d'installation - Page 29

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Miele DA 2390. Miele DA 2390 40 pages. Ventilation system
Également pour Miele DA 2390 : Instructions d'utilisation et d'installation (40 pages), Instructions d'utilisation et d'installation (40 pages), Instructions d'utilisation et d'installation (36 pages), Instructions d'utilisation et d'installation (36 pages), Instructions d'utilisation et d'installation (36 pages)

Imprimer la page
Miele DA 2390 Instructions d'utilisation et d'installation
 Fit one of the screws supplied into
each lamp holder.
 Tighten the screws with a screwdriver
until the frame sits flush with the
installation surface.
Do not overtighten the screws!
 Replace the lamps.

Connection for air extraction

If the cooker hood is used at the
same time as a heating appliance
that relies on oxygen from the same
room, there is a risk in certain
circumstances of toxic fumes
building up.
It is essential that the "Warning and
Safety" instructions are observed.
The cooker hood should be installed
according to local and national
building regulations. Seek approval
from the building inspector where
necessary.
For ducting, use smooth pipes or
flexible ducting made from approved
non-flammable materials.
To achieve the most efficient air flow
rate with the lowest noise levels, please
note the following:
– The diameter of the exhaust ducting
should not be less than 150 mm.
– If flat ducting is being used, the cross
section must not be smaller than the
cross sectional area of the exhaust
connection.
– The ducting should be as short and
straight as possible.
– Only use wide radius bends.
– The ducting must not be kinked or
compressed.
– Ensure that all connections are
strong and airtight.
Remember that any constriction of
the air flow will reduce the air flow
rate and increase operating noise.
Installation
29