Miele DA 424 V EXT Instructions d'utilisation et d'installation - Page 18

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Miele DA 424 V EXT. Miele DA 424 V EXT 36 pages. With extended canopy
Également pour Miele DA 424 V EXT : Instructions d'utilisation et d'installation (40 pages), Dimensions du produit (2 pages), Manuel d'utilisation et d'installation (36 pages), Instructions d'utilisation et d'installation (36 pages), Instructions d'utilisation et d'installation (36 pages), Instructions d'utilisation et d'installation (40 pages)

Miele DA 424 V EXT Instructions d'utilisation et d'installation

Cleaning and care

,
Before carrying out any cleaning
or maintenance work, disconnect
the rangehood from the mains
supply. Ensure that:
– it is switched off at the isolator, or
– the mains fuse is disconnected, or
– the screw-out fuse is removed (in
countries where this is applicable).
,
Exercise caution when changing
halogen lamps. They get very hot
during use, and remain hot for some
time after being switched off. Do not
touch the surface directly when
changing a lamp, as grease
particles from your fingers will
adhere to the surface and damage
it.
The halogen lamps can also be
damaged if water is used to clean
them.
Wait several minutes after switching
off before beginning cleaning.
A range of Miele branded cleaning and
conditioning agents are available to
order through your Miele Chartered
Agent, from Miele, or via the internet at
www.miele-shop.com.
18

Housing

General notes
The surfaces and controls are
susceptible to scratches and
abrasions. Please observe the
following cleaning instructions.
^ All external surfaces and controls can
be cleaned with warm water and a
small amount of washing-up liquid
applied with a well wrung-out soft
sponge or cloth.
^ Wipe the surfaces dry using a soft
cloth.
Do not use too much water when
cleaning the controls. Water could
penetrate into the electronics and
cause damage.
Avoid:
– cleaning agents containing soda,
acids, chlorides or solvents,
– abrasive cleaning agents, e.g.
powder cleaners or cream cleaners
and abrasive sponges, as well as pot
scourers or sponges which have
been used previously with abrasive
cleaning agents.
These will damage the surface
material.