HP 3000 969KS/220 Manuel - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} HP 3000 969KS/220. HP 3000 969KS/220 20 pages. 9x9 to k class conversion

Replacing the Core I/O card

To replace the Core I/O card;

•

Loosen the top and bottom screws securing the Core I/O card to the chassis

•

If the existing Core I/O has extractor handles:

1. Lift the extractor handles and slide the Core I/O card out of the chassis.

2. The new Core I/O card no longer incorporates extractor handles, so the metal tabs

used by the extractor handles must be removed from the chassis before the new Core

I/O card can be installed. These tabs are located at the top and bottom of the slot

occupied by the Core I/O card and are secured by a #15 Torx screw. Discard the metal

tabs after removing them.

•

If the existing Core I/O DOES NOT have extractor handles, pull the card out of the chassis using

the pull ring located at the top of the board and slide the Core I/O out of the chassis.

•

Install the new HP 9000 Core I/O card.

To install the Modem Distribution Panel (MDP);

•

Install the Overlay on the MDP

•

Connect the ADP cable to the MUX connector on the Core I/O card

•

Connect the ADP cable to the MDP

•

Remove the console cable from the console and connect the new cable to the console and the port

on the Core I/O marked "Console"

•

If there is a Remote Support Modem, connect its cable to the port on the MDP marked "Remote

Console"

If a UPS is connected to the UPS port on the HP 3000 Core I/O card, move its cable to the "UPS"

port on the new HP9000 Core I/O card.

Stable Storage must be updated to include the new values appropriate for the HP 9000 being

converted to. SW_ID will not need to be changed.

Conversion Procedures 7