HP 3000 Series Manuel de mise à jour - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de mise à jour pour {nom_de_la_catégorie} HP 3000 Series. HP 3000 Series 19 pages. 9x9 to k class conversion
Également pour HP 3000 Series : Manuel (25 pages), Manuel (20 pages), Manuel d'installation (42 pages)

Imprimer la page

CPU Upgrade

Installation Verification

6. Type PR (the processor command) and press

processors, as shown in the following example:

Processor

Speed

---------

-----

100 Mhz

Central Bus Speed (in Mhz)

Software ID (dec)

Software ID (hex)

Software Capability

NOTE

Values displayed will vary depending on the system model.

The example shows that CPU 0 and CPU 1 are both Active. A Non-Responding message indicates a

problem. For example, a non-responding CPU could be one that failed its selftest when the computer

was turned on. A Deconfigured message indicates that the processor was deconfigured by the user

from the Configuration Menu.

Check to ensure that the correct quantity of processors are installed and the speed values are all the

same.

7. If all CPUs are listed as "active" or "idle," type BO PRI at the Information menu prompt, and press

Enter. This boots the system from the primary boot path. If your computer uses a different boot

device or path, you should boot from that path.

8. If there is a failure or non-response, reseat the CPU identified as Non- Responding by following the

Adding CPU #1 procedures, or if applicable, the Adding CPUs #2 - 3 or #4 - 5 procedures to access

the CPU. Perform the following steps:

a. Make sure that the key is in the OFF position.

b. Grasp the CPU by the edge and gently pull until it comes loose.

c. Check the CPU slot alignment and re-insert the CPU card into the appropriate slot until it is fully

seated.

d. Perform the Verification procedures again.

PROCESSOR INFORMATION

HVERSION Model

SVERSION Model/Op

--------

0x0583

This will display all the installed and configured

Enter.

CVERSION

--------

0x0000

100

0x000000000

0x1000000F1

Processor State

--------

---------

Active