HP 8530w - EliteBook Mobile Workstation Manuel d'installation et de configuration - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de configuration pour {nom_de_la_catégorie} HP 8530w - EliteBook Mobile Workstation. HP 8530w - EliteBook Mobile Workstation 18 pages. Hp elitebook mobile workstation
Également pour HP 8530w - EliteBook Mobile Workstation : Brochure & Specs (8 pages), Quickspecs (36 pages), Manuel de l'utilisateur (15 pages), Brochure & Specs (4 pages), Manuel du réseau (16 pages), Spécifications (4 pages), Manuel des accessoires (2 pages), Brochure & Specs (6 pages), Manuel de l'utilisateur (27 pages), Manuel de configuration (19 pages), Vue d'ensemble (16 pages), Manuallines (12 pages), Manuel d'installation du logiciel (8 pages), Manuallines (6 pages), Manuel (20 pages), Manuallines (7 pages), Manuel de l'utilisateur (28 pages), Quickspecs (47 pages)

so counting dashes PIDs are 9 characters and PPS are 40 characters. They must be

generated by an S&CS.

The Admin Password, PID, and PPS can be populated by the use of a pre-generated USB key

generated by the ISV Management Console.

20) Skip Un-Provision.

For AMT 2.x, this option is to return the system to factory defaults. For AMT 4.x, the

unprovision option in MEBx will not reset the system to factory default. See the Return to

Default section for more information on unprovisioning.

21) Check SOL/IDE-R.

a. A message window telling the user that the system resets after configuration will

appear.

i. Select Y.

b. Username and Password

Default Setting

Recommended Setting

i. Select Enabled.

This option allows users and passwords to be added from the WebGUI. If it is

disabled, then only the administrator has MEBx remote access.

c. Serial Over LAN

Default Setting

Recommended Setting

i. Select Enabled.

d. IDE Redirection

Default Setting

Recommended Setting

i. Select Enabled.

22) Skip Secure Firmware Update.

Important Note: You may have to use the arrow keys to scroll down and see the following

options.

23) Go into Set PRTC.

Default Setting

Recommended Setting

This option sets the PRTC (Protected Real Time Clock). It is used with TLS mutual authentication

which checks for the client certificate for expiration based on its PRTC.

PRTC has a valid date range of 1/1/2004 to 1/4/2021.

24) Skip Idle Timeout.

: Enabled

: None

: Current Date and Time in GMT (UTC)