Allnet ALL168500 Manuel d'installation rapide - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allnet ALL168500. Allnet ALL168500 10 pages. 500 mbps plc ethernet bridge
Imprimer la page
LEDs
PWR
(Red)
PLC
(Green/Orange/Red)
ETH
(Green)
*1 : The "PWR" LED indicator will blink in standby mode. It will automatically get into standby mode, if the
Ethernet-link is lost for 60 seconds. If you unplug the Ethernet cable, it will get into standby mode after 60
seconds. Under standby mode, PLC and ETH LEDs will both be off.
Push Buttons
(Only applicable for models with push button)
Push button functions are disabled under Standby mode.
Setup Button Usage:
1. First time to setup your private network:
Step 1. Press and hold the device's "SETUP" button for more than 10 seconds. You can release the button
when you see all the device's LEDs are off and restart. The original network encryption setting is
cleared.
Step 2. Repeat Step 1 to clear another device's original network encryption setting.
Step 3. Press both devices' "SETUP" button for 1 to 3 seconds. You will see both devices' "PWR" LED start
blinking. Both devices start to communicate and try to setup their private network encryption. They will
complete the new private network encryption setting within 10 seconds. You will see both devices' all
LEDs are off and restart.
Note: The setup operation timeout is 120 seconds.
Step 4. If failed, please repeat Step 1 to Step 3 again.
2. Add a new device to the existing private network:
Step 1. Plug the new device. Press and hold its "SETUP" button for more than 10 seconds to clear the original
network encryption setting.
Step 2. Press the new device's "SETUP" button for 1 to 3 seconds. The "PWR" LED starts blinking.
Step 3. Select a random device from the existing private network. Press its "SETUP" button for 1 to 3
seconds. The device's "PWR" LED starts blinking.
Step 4. The new device starts to communicate with the device from existing private network, and tries to join
this existing private network. It will complete the new private network encryption setting within 10
seconds. You will see the new device's all LEDs are off and restart after completing the private
network setting. The existing private network device's "PWR" LED become solid.
ALL168500 QIG
On: Power on
Blinking: Standby mode (*1)
Off: Power off
On: Powerline Link detected and no traffic
Blinking: Powerline traffic detected
Green: The Powerline connection quality is good
Orange: The Powerline connection quality is fair
Red: The Powerline connection quality is bad
Off: No Powerline Link detected
On: Ethernet Link detected
Blinking: Ethernet traffic detected
Off: No Ethernet Link detected
ALLNET GmbH © 2010
www.allnet.de