Miele KM 346 G Series Informations techniques - Page 4

Parcourez en ligne ou téléchargez le pdf Informations techniques pour {nom_de_la_catégorie} Miele KM 346 G Series. Miele KM 346 G Series 25 pages.

Imprimer la page
Miele KM 346 G Series Informations techniques
Technical Information
A

Warning and Safety Instructions

1
General Information
Service and repair work should only be carried out by a suitably qualified
electrician (with specialist training, knowledge and experience, and recent
related work experience) in accordance with all appropriate local and national
safety regulations.
Servicing, modification, testing and maintenance of electrical appliances
should only be carried out in accordance with all appropriate legal
requirements, accident prevention regulations and valid standards.
Unless absolutely necessary, e.g., fault finding with supply voltage, working
on a machine connected to the power supply should always be avoided. If
working on a machine with an applied voltage at a potentially dangerous level
is unavoidable, special safety measures must be taken into consideration and
complied with.
Before starting any service work, the machine must be disconnected from the
power supply. Suitable measurements must be made to ensure that this is
the case.
Even with the machine switched off, voltage may be applied to some
components.
A general visual check should always be carried out.
There may be a risk of injury due to protruding parts. Protective goggles
should be worn.
There may be a risk of injury due to sharp edges. Protective gloves should be
worn and the edge protection, mat. no. 05057680, should be used.
2
Touch Current Measurement
Note:
On machines with a ground connection, touch current leakage
measurements should be carried out on all accessible conductive parts that
are not connected to ground.
Warning!
Touch current measurement should only be carried out after the ground
connection of the appliance under test has been checked and found to be
satisfactory! Dangerous voltages may exist on defective machines as well as
on accessible conductive parts that are not connected to ground!
Note:
Touch current measurement should be carried out on the following
accessible conductive parts:
None.
KM 34xx Gas Cooktops
4