365SMART SM-02-02900 Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 365SMART SM-02-02900. 365SMART SM-02-02900 20 pages. Drywall sander

Imprimer la page

• Wear personal protective equipment and safety

goggles. The use of personal protective equipment

(dust masks, hearing protectors, helmets, protective

footwear) reduces the risk of injury.

• Avoid unintentional switching on of the power tool.

Before connecting the tool to the mains, make sure

the power switch is in the OFF position. Holding your

finger on the switch or connecting the power tool

when the switch is in the ON position can cause

serious injury.

• Remove all wrenches and other setting tools before

switching on the tool. Left wrenches in the moving

parts of the tool can lead to serious injury.

• Maintain a stable body position while working. This

will allow better control of the tool in case of

unexpected working situations.

• Wear appropriate clothing. Do not wear loose

clothing and jewellery. Keep hair, clothing and

working gloves away from the moving parts of the

tool. Loose clothing, jewellery or long hair can be

pulled in by the moving parts of the tool.

• If it is possible to connect dust extraction and capture

equipment, make sure that it has been installed

correctly. The use of extraction reduces the risk of

dust hazards.

Special safety instructions for using the plaster

grinder.

The appliance may be used by persons without

experience or knowledge if they receive appropriate

supervision or safety instructions and understand the

hazards.

• This power tool is designed to work as a wall and

ceiling grinder. Read all safety warnings, instructions,

illustrations and technical data supplied with this

power tool. Failure to follow the instructions may

result in electric shock, fire and/or serious injury.

• The grinder is not waterproof and should therefore

only be used for dry sanding. Water penetration

inside the power tool can cause an electric shock.

• Do not use accessories that are not specifically

designed and recommended by the manufacturer.

The ability to connect accessories to the power tool

does not guarantee safe working.

• The rated speed of the accessory must be at least

equal to the maximum speed marked on the power

tool. Accessories running faster than their rated

speed may become damaged.

• The outer diameter and thickness of the accessory

must be within the permitted capacity of the power

tool. Incorrectly selected accessories cannot be

adequately protected or controlled.

• The diameter of the sandpaper discs must be exactly

matched to the sanding pad. Accessories that do not

match the attachment of the power tool will rotate

unevenly, may vibrate severely and cause you to lose

control of the tool.

• Do not use damaged accessories. Before each use,

check the condition of accessories such as abrasive

discs for wear and cracks, sanding pad for cracks,

tears or excessive wear. If the power tool or its

component is dropped, check for damage or install

undamaged

accessories.

installing the accessories, run the power tool for one

minute at maximum speed with no load.

• Wear personal protective equipment. Depending on

the type of work, use face shield, safety goggles. If

necessary, wear a dust mask, hearing protection,

gloves and a work apron capable of retaining fine

abrasive material or fragments of the workpiece. Eye

protection must be able to stop flying debris

resulting from the grinding operation. The dust mask

or respirator must be capable of filtering out particles

generated during work. Prolonged exposure to high-

intensity noise can cause hearing damage.

• Keep a safe distance from the work area for

bystanders. Every person entering the workplace

must wear personal protective equipment. Parts of

the workpiece or damaged accessories may fall off

and cause injury.

• Place the cable at a safe distance from rotating

accessories. If control is lost, the cable may be cut

or snagged, which could cause hands to be drawn

into the rotating attachment.

After

checking

and