DIAKAT RK-10 Manuel de l'opérateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} DIAKAT RK-10. DIAKAT RK-10 9 pages. Roofing saw

Imprimer la page

RK10

RK10S S S S

RK10

Roofing saw

BEFORE STARTING

3.1. Visual check up of the machine state

Regularly (before commencing work) check:

•

all covers and safety features (overall state of machine)

•

inside of the cover (check for fouling)

•

all screwed joints

•

sealing of fuel and lubrication system

•

cleanness of air filter (see engine manual)

•

oil level (see engine manual)

•

fuel level (HONDA– Natural 95)

•

state of tool's wear

Remedy all faults or fouling before commencing work!

WORKING WITH THE MACHINE

4.1. Mounting of the tool

!Attention! Before any manipulation check if the engine is switched off. When changing

the tool you can tilt the machine on its handlebars to 45°.

1. Loosen the M 20 nut on the tool spindle and take off the outside flange.

2. Mount the tuck point or crack chaser with bore 25,4 mm on the spindle and remount

the flange. Check the indicated sense of rotation.

4. Retighten the M20 nut.

4.2. Working with the machine

!ATTENTION! Never start the engine if the tool is touching the ground.

1. Pull and depress the handlebars towards you and lift the machine to upper

transporting position, the brace will click in a secure the position. Make sure that the

tool is not touching the ground, if yeas, adjust with the threaded rod.

2. Bring the machine above the intended cut.

3. Start the engine (see the engine manual), set the throttle to maximum revs.

4. Pull the handlebars and the rod (it will release the mechanical brace) and slowly

lower the machine. Set depth of cut by the knob on the rod. Lock the rod in the set

depth by the plastic locking ring.

5. Move the machine slowly and steadily forward.

6. When the cut is finished repeat step 1 and set idling revs, move the machine to next

cut, slightly tilt the machine and pull the rod, lower the machine in the cut, it will cut to

the depth preset in step 4.

Page 7 of 8