DIAL ENGINEERING IUPITER Series Manuel d'utilisation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} DIAL ENGINEERING IUPITER Series. DIAL ENGINEERING IUPITER Series 13 pages. 24 v/10 a
Également pour DIAL ENGINEERING IUPITER Series : Manuel d'utilisation (17 pages)
Imprimer la page
Description
The IUPITER chargers are battery chargers built in primary technology with
wide-range input and active PFC. The devices are built in protection class II
version. They provide a constant direct voltage and direct current with little
ripple. The charger is housed in an aluminum enclosure.
The battery output is short-circuit proof and equipped with an overvoltage and
reverse polarity protection. The battery is separated from the charge control-
ler and protected by a fuse. The charger disposes of a potential-free contact
as immobilizer system for onboard applications e.g. in cleaning machines.
Several internal sensors for temperature control have been installed in the
device. In the case of too high temperatures the charging current is reduced
or the charging process is canceled.
The charging process is displayed by means of one LED.
EN
Indicating elements
Display
Description
LED RED
Switching on / self test.
briefly flash
During the self test when switching on
the charger the LED briefly flashes.
LED RED
Charging
illuminates
The battery is charged with nominal cur-
rent. The LED illuminates until the battery is
charged by approx. 90%.
LED RED
The device is in the last charging phase.
flashes
NO LED
Charging process completed
illuminated
The battery is charged by 100% and the
charger is in the trickle charging.
If the battery is not fully charged a failure /
mailfunction has occurred.
> See chapter «Troubleshooting».
LED RED
Critical failure / malfunction
always on
A critical electronics or software error
has occured.
> See chapter «Troubleshooting».
EN