Allo.com 2nd Gen E1/T1/J1 Manuel d'installation rapide - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allo.com 2nd Gen E1/T1/J1. Allo.com 2nd Gen E1/T1/J1 8 pages. Pri card

Imprimer la page

Generation E1/T1 PRI Card Installation

If this is your first Asterisk Install, you should install the sample configuration files, to

do this run:

# make samples

Software Configurations:

After compiling and installing DAHDI and Asterisk, load the Dahdi driver by running:

# /etc/init.d/dahdi start

# dahdi_genconf –vvv

If there is any error, please trace the cause. Until all errors are clear up, you should

execute "dahdi_genconf" again, and then go to the next step.

By running "dahdi_genconf", it will generate /etc/dahdi/system.conf and

etc/asterisk/dahdi-channels.conf automatically. Checking whether the generated files

information agrees with your hardware setup, if not, you should modify to your

specific requirements.

Do not forget to confirm dahdi-channels.conf is included in chan_dahdi.conf to

configure dahdi channels with asterisk, if not, run command:

# echo "#include dahdi-channels.conf" >> /etc/asterisk/chan_dahdi.conf

Execute the following command:

# dahdi_cfg –vvvvvv

This command is used for reading and loading parameters in the configuration file

system.conf and writing to the hardware.

Start the Asterisk by executing

# asterisk –gvvvvvvvvvc

Makesure that PRI spans are up and active, before making calls.Here is the

command to check the pri span status

CLI> pri show spans

Quick Installation Guide v1.0