Diall 2931 Instructions de sécurité et d'assemblage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de sécurité et d'assemblage pour {nom_de_la_catégorie} Diall 2931. Diall 2931 4 pages. Rechargeable 1 million candle power spotlight

Imprimer la page

Operating Instructions

• Push the handle button and turn the handle to upper or lower position. Upper pistol

for pin pointing long range objects, lower lantern profile for searching around

• Charge the battery prior to initial use (see CHARGING THE BATTERY).

• Turn the lantern ON and OFF by the switch on the main body.

Charging the Battery

The spotlight must be switched "OFF" whilst charging.

• AC/DC adaptor charging the battery

Plug the charger into the wall outlet. Insert the charger plug into the DC jack of the

spotlight; Time required to fully charge the battery is approximately 20 hours.

• Car plug adaptor charging the battery

Plug the included car plug adaptor into the cigarette lighter socket on your car (truck

or boat ),insert the adaptor plug into the DC jack of the spotlight. This method is

recommended for emergencies or for a quick charge only. This method should not

be used for long-term charging. Charge the spotlight for no longer than 2 hours.

CHANGING THE HALOGEN BULB: Replacement bulb type:H3 6V 35W

1. Remove the reflector assembly by turning the head cover anticlockwise.

2. Life out the reflector assembly taking care not to pull on the wires.

3. Remove cable tie.

4. Slide sleeve downwards.

5. Slide clear plastic insulation sleeve downwards.

6. Disconnect spade connector.

7. To remove the bulb, squeeze the wire clip and slide it out through it's slot. Note which

way round it faces.

8. Life out the old bulb.

9. Replace the bulb with a new H3 6V 35W halogen bulb.

Do not touch the glass with your bare hands as finger grease will significantly reduce

the life of the bulb. In the case of inadvertent finger contact, simply clean the glass

thoroughly with a cloth moistened with methylated spirit.

10.Re-connect the connector with that of the new bulb ensuring the insulation fully covers

the connector.

11.Clip the spring wire back into place.

12.Refit the reflector assembly ensuring correct alignment.

mw*

W-S-H-HHS

B&Q pic, Chandlers Ford.Hampshire.S053 3YX

Visit us at www.diy.com

04054979

110721