Dialog Semiconductor DA9070 Manuel de l'utilisateur - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dialog Semiconductor DA9070. Dialog Semiconductor DA9070 18 pages. Fuel gauge development kit

Imprimer la page
UM-PM-039
DA9070 / DA9231 Fuel Gauge Development Kit

Battery Profile Mode

The DA9070 Fuel gauge EVK board can also be configured to perform battery characterization
(battery profile) and run a fuel gauge performance test. This is done using the Power Profile Manager
(PPM) software instead of the DA9070 Fuel Gauge GUI. The profile data for a specific battery is
generated by the PPM and loaded to the MCU. This profile is then used by the pre-loaded Dialog
algorithm for the SOC fuel gauge.
If the included 80mAh battery is used, battery profiling is not necessary; the MCU is pre-loaded with
both the fuel gauge algorithm and 80mAh battery profile.
Also pre-loaded to the MCU is the eval board calibration data. The calibration steps are described in
AN-SW-121 but do not need to be performed in most cases.
Figure 9
shows the jumper set-up of the DA9070 Fuel gauge board while battery profiling is running.
Note the jumper position of J14 in battery profile mode.

Figure 9: Jumper Settings for Battery Profile Mode

User Manual
J8
J27
J24
J6
Revision 2.1
16 of 18
BATTERY
PROFILE
MODE
J2
J14
J20
J19
J12
J15
J25
J23
J22
© 2018 Dialog Semiconductor
NDA Confidential
J9
J10
J11
J18
28-Oct-2018