Alloy LED AL-60-03-0001 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Alloy LED AL-60-03-0001. Alloy LED AL-60-03-0001 2 pages. Remote control dimmer switch
Imprimer la page
Setup
How to Pair the Wireless Receiver (AL-60-03-0004) and Remote Control
1. Connect the components according to the diagram on the other side of this sheet.
2. Wake up the remote control by touching the ON/OFF button. The red power indicator will light up.
3. Short press the "Learning Key" button on the receiver.
4. Touch any of the 4 zone buttons on the remote control. If only setting up one zone, simply press the "1" button.
5. Then touch the color wheel.
6. The connected LED lights will blink to confirm the zone designation.
How to Unpair the Wireless Receiver and Remote Control
1. Hold down the "Learning Key" button on the receiver for about 5 seconds. When the LED lights flash, the remote has been unpaired.
Multiple Zones and Multiple Remote Controls
Note: Only one master controller can be assigned to each zone. After a period of time, the master will do a synchronization operation to keep the
same color or mode of all receivers in one zone.
1. To Set Up Multiple Zones: Each remote controller can control up to 4 zones via the Wireless Receivers, and multiple Wireless Receivers
can be set to a single zone. To set up multiple zones, repeat the steps above in "How to Pair", assigning each zone its own number from
1-4.
2. To Set Up Multiple Remotes to Control the Same Wireless Receiver: Each Wireless Receiver can be controlled by a maximum of 8
different remote controllers. To set up, repeat the steps above in "How to Pair" for each remote.
Wiring Diagram
page 2 of 2
www.AlloyLED.com / support
Specifications subject to change without notice.
AlloyLED.com / 800.910.LEDS (5337)
@