AlloyGator AlloyGator Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} AlloyGator AlloyGator. AlloyGator AlloyGator 4 pages.

Imprimer la page

For best results, please read carefully before attempting to fit your AlloyGators.

You may also find it useful to visit www.alloygator.com and watch the short fitting video.

WARNING: It is important to monitor tyre pressures in line with your vehicle handbook recommendations. Substantial loss of pressure

could result in the AlloyGator moving or, in extreme cases, coming out from between the wheel and tyre.

PLEASE NOTE: We recommend you regularly clean your wheels and AlloyGators with normal car shampoo or universal wheel cleaners

suitable for delicate finishes like chrome. Avoid the harsh cleaners and thick, brush-on tyre shines used by some hand car washes.

For professional fitting by our dealer network go to www.alloygator.com and click on 'find a fitter' for your nearest stockist.

fig.7

fig.10

1mm

Gently tap the AlloyGator back into

position making sure the ends mesh

together along the locking teeth

(fig.7). Before tapping all the way in,

run a small amount of glue along the

teeth between the two ends (fig.8).

Firmly tap them into place hitting at a

right angle to the wheel to make sure

that the ends line up with each other.

Working anti-clockwise, and hitting

away from the centre of the rim,

seat the AlloyGator onto the wheel all

the way round (fig.9). Do the same

for the joint using a square-on blow

across both ends at the same time

ensuring you apply equal pressure.

Avoid hitting one side more firmly

than the other. Inflate tyre to 10–15

psi and repeat for another rotation.

fig.8

fig.11

Re-inflate the tyre in accordance

with your vehicle handbook and again

hitting away from the centre of the

rim, seat the AlloyGator into its final

position. There should be a slight gap

but no more than a 1mm between

the AlloyGator and the wheel (fig.10).

When you have finally seated the

AlloyGator profile, ensure that you

do not have a gap at the back of the

AlloyGator between it and the tyre.

Please contact us should you need

clarification on this.

To fit the joint cover apply 4-6 dabs

of glue evenly onto the underside of

the cover (fig.11) and push the peg

that is on the underside into the hole

in the AlloyGator. Hold in place for 20

seconds (fig.12).

fig.9

fig.12

Lower the wheel to the ground and

remove jack. Repeat above until all

wheels are protected.

Vehicle tyre pressures should be

checked an hour after fitting to

ensure there is no loss of air and then

at regular intervals in accordance

with your vehicle handbook. If you

damage your AlloyGator please refer

to our care advice and 'How To'

videos.