Create dhcpd.conf file
Create the dhcpd.conf file. The IP information, codec information, and protocol information for
the IMG and GCEMS server should be determined before starting the xldhcpd script. Also, the
MAC address of the CTRL 0 interface can be obtained from sticker located on bottom of IMG
1010 chassis.
1. As Super User, create a dhcpd.conf file. Run the dhcpd file creation script located in
the following /opt/dialogic/common/osconfig directory.
[root@localhost]#./xldhcp
2. Enter values when prompted as appropriate for your configuration. You will be
prompted for the following information: [factory defaults shown in bold]
Router/Default Gateway IP Address: [192.168.0.1]
Router/Default Gateway Subnet Mask: [255.255.255.0]
Subnet IP Address: (Router/Default Gateway IP Address - 1) [192.168.0.0]
FTP Server IP Address: (This PC IP Address) [192.168.0.100]
How many IMG systems are being configured? [1]
T1 or E1 IMG ( t/ e)? [t]
CODEC Profile Selection
1 = LBR
2 = LBR + iLBC
3 = LBR + iLBC + wireless
[NOTE: You must have a license for wireless codecs. You must also set host flags
accordingly (see Vocoder Information)]
Enter CODEC profile? [2]
IMG(CTRL0)[1] IP Address: [192.168.0.102]
IMG(CTRL0)[1] MAC Address:
IMG(CTRL1)[1] MAC Address: (MAC shown on IMG Label +1) [00:20:1C:xx:xx:xx+1]
Note: Assign an IP address to the IMG CTRL 0 interface that is on the same subnet as
the GCEMS server. Once this IP address is set, the GCEMS will be able to connect to
and configure the IMG
3. The following is the response after all prompts are complete:
dhcpd.conf created with 1 IMG's configured...
4. The file will be created in the /opt/dialogic/common/osconfig directory.
5. Move the file to the /etc directory
mv dhcpd.conf /etc)
(MAC shown on IMG Label) [00:20:1C:xx:xx:xx]
IMG 1010 Quick Start Guide
15
Imprimer la page