Dialogic IMG 1010 Manuel de démarrage rapide - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dialogic IMG 1010. Dialogic IMG 1010 10 pages. Connecting dc power
Également pour Dialogic IMG 1010 : Manuel d'instructions d'installation (6 pages), Manuel de démarrage rapide (11 pages), Manuel de démarrage rapide (18 pages), Manuel de démarrage rapide (10 pages), Manuel d'instructions d'installation (9 pages), Manuel de démarrage rapide (4 pages)

Connecting TDM Signaling and Bearer Ports

The Bearer ports (Interface Offsets) 0-27 are connected to the TDM network. Each

•

Bearer Port can have signaling and bearer channels configured on it.

The Signaling/Timing Ports are connected to the TDM network, and can also be used

•

for signaling and bearer traffic the same as the Bearer ports. See the 'T1/E1' under

the 'Configuration' section in the online help for more information.

SS7 Signaling links and ISDN D-channnels can be brought in over either the

•

Signal/Timing Ports or the Bearer Ports. See 'signaling' under the 'Configuration'

section in the Online Documentation for more information.

Once the IMG 1010 has software installed, the cabling is connected, and the GCEMS

server has been configured, the ClientView application can be used to configure the

system. Below are a few topics from the Online Documentation to get started on

configuring the IMG 1010 through the ClientView GUI.

Configuration > ClientView > (All topics under this book)

•

Configuration > Introduction

•

Configuration > Node Configuration Wizard

•

Configuration > Basic Configuration

•

From here, the IMG 1010 can be configured for your network. Use the Online Manual

Configuration, Clientview, and ClientView Pane sections to configure the IMG 1010.

Dialogic Corporation

IMG 1010 Quick Start Guide

Part # 07-8728-04

Page 9 of 9