Allpro 288681 Instructions - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} Allpro 288681. Allpro 288681 4 pages. Mustang 500 series spray guns

Imprimer la page
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
•
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•
Do not exceed the maximum working pressure or temperature rating of the lowest rated system component.
See Technical Data in all equipment manuals.
•
Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equip-
ment manuals. Read fluid and solvent manufacturer's warnings. For complete information about your mate-
rial, request MSDS forms from distributor or retailer.
•
Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manufacturer's
replacement parts only.
•
Do not alter or modify equipment.
•
Use equipment only for its intended purpose. Call your distributor for information.
•
Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
•
Do not kink or over bend hoses or use hoses to pull equipment.
•
Keep children and animals away from work area.
•
Comply with all applicable safety regulations.
PRESSURIZED ALUMINUM PARTS HAZARD
Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing
such solvents in pressurized aluminum equipment. Such use can cause serious chemical reaction and equipment
rupture, and result in death, serious injury, and property damage.
Related Manuals
This manual is available in the following languages.
Manual
Language
312364
Spanish
312365
French
Pressure Relief Procedure
Follow this Pressure Relief Procedure whenever you are
instructed to relieve pressure, stop spraying, check or service
equipment, or install or clean spray tip.
1.
Turn OFF power and turn sprayer pressure control to
lowest pressure setting.
2.
Hold gun against side of flushing pail. Trigger gun into pail
to relieve pressure.
If you suspect spray tip or hose is clogged or that pressure has
not been fully relieved after following the steps above, VERY
SLOWLY loosen tip guard retaining nut or hose end coupling
to relieve pressure gradually, then loosen completely. Clear
hose or tip obstruction.
2
WARNING
Gun Trigger Lock
To prevent injury when the gun is not in use, always engage
the gun's trigger lock if unit is being shut down or left
unattended.
Trigger
Locked
(no spray)
Setup
Make sure sprayer is turned off and unplugged from power
source. Refer to your sprayer instruction manual for priming
and spray instructions.
Connect Gun to Sprayer
1.
Attach supply hose to sprayer fluid outlet.
2.
Attach other end of supply hose to gun swivel. Use two
wrenches (one on the swivel and one on the hose) to
tighten all connections securely.
3.
Refer to sprayer instruction manual for priming
instructions.
Trigger
Unlocked
(spray)
ti10352a
ti10353a
312363E