Diamatic BS-110 MKIII Manuel d'utilisation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Diamatic BS-110 MKIII. Diamatic BS-110 MKIII 16 pages.

Blade changing

Dull blades greatly reduce cutting ability. Re-sharpen or replace as needed. Always wear gloves when changing

blades. Use extended wrench to keep hand safely away from the edge of the blade.

Place a bock (1) under the front of the machine and loose the five hex head bolts and replace the blade. It is

not necessary to remove the bolts. Be sure that the blade is far enough under the blade holder, to insure a

secure hold.

Always wear gloves and safety glasses. It is not necessary to remove the bolts. Sharpen the blade mounted to

the machine. Using hand grinder, block up front of machine so blade is off the floor. Sharpen the blade with a

10 cm diameter disk with 120 or finer grit. Be careful not catch disk on edge or corner of blade.

Blade bevel up

Blade bevel down

Furthermore there is the opportunity to remove the blade from the machine and to sharpen the blade at a

vice, obeying the same way as shown in figures above.

The machine must be off before plugging the machine into power source.

1. Selection switch must be on '0' position

2. Turn speed control to slowest position.

3. Plug in the main plug.

4. Turn the selection switch to '2' position.

5. Engage forward or reserve switch.

6. Increase speed control to desired speed.

The frequency drive has been factory set, do not change any setting of the frequency drive.

Do not lock the wheel drive into a permanent position. If the operator would lose control or be disabled,

the machine continues to operate.