Miller SUBARC WIRE DRIVE 400 T CE Manuel du propriétaire - Page 16
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller SUBARC WIRE DRIVE 400 T CE. Miller SUBARC WIRE DRIVE 400 T CE 28 pages.
Imprimer la page
5-1. Installing Wire Guide And Drive Roll
.
Motor shown without feed roller guard.
Tools Needed:
1/4 in.
5-2. Plug Connections
2
5-3. Remote Receptacle RC2 Information
REMOTE 10
Wirefeed Drive
Motor Hookups
OM-253789 Page 12
SECTION 5 − INSTALLATION
6
5
4
3
2
1
3
.
Motor shown without feed roller guard.
Socket
A
Negative (−) motor armature (38 VDC motor).
B
Encoder common and motor identification (resistor across H and B).
C
Shield drain leads.
F
Positive volt sense.
H
Motor identification (resistor across H and B).
I
Encoder VCC (+5 VDC).
J
Positive (+) motor armature (38 VDC motor).
K
Encoder channel A.
.
When changing wire size or type,
check drive roll size
(see Table 5-1).
1
Wire Pressure Adjustment Screw
Loosen screw to decrease tension on
spring.
2
Drive Roll Nut
3
Drive Roll (Not Supplied)
Remove drive roll.
4
Drive Roll Carrier
Turn nut one click to line up lobes with
lobes on drive roll carrier.
5
Wire Guide Securing Screw (Hidden)
Loosen wire guide screw.
6
Inlet Wire Guide (Supplied With Wire
Straightener Kit)
Remove inlet wire guide.
Install drive rolls, and turn drive roll nut one
1
click.
1
Subarc Interface (Digital
Shown)
2
Motor Control Cord Part No.
254232XXX
XXX indicates cable length.
3
Wire Drive
To make connections, align key-
way, insert plug, and tighten
threaded collar.
Socket Information
Ref. 265710-A
265711-A