ABB DODGE USN 314 Manuel
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ABB DODGE USN 314. ABB DODGE USN 314 16 pages. Adapter mount & direct mount plummer blocks
DODGE
200 and 300 Series Direct Mount Plummer Blocks
These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of
printing. Please see baldor.com for updated instruction manuals.
Note! The manufacturer of these products, Baldor Electric Company, became ABB Motors and Mechanical Inc. on
March 1, 2018. Nameplates, Declaration of Conformity and other collateral material may contain the company name of
Baldor Electric Company and the brand names of Baldor-Dodge and Baldor-Reliance until such time as all materials have
been updated to reflect our new corporate identity.
WARNING: To ensure the drive is not unexpectedly
started, turn off and lock-out or tag power source before
proceeding. Failure to observe these precautions could
result in bodily injury.
WARNING: All products over 25 kg (55 lbs) are noted on the
shipping package. Proper lifting practices are required for
these products.
WARNING: Because of the possible danger to person(s)
or property from accidents which may result from the
improper use of products, it is important that correct
procedures be followed. Products must be used in
accordance with the engineering information specified
in the catalog. Proper installation, maintenance and
operation procedures must be observed. The instructions
in the instruction manuals must be followed. Inspections
should be made as necessary to assure safe operation
under prevailing conditions. Proper guards and other
suitable safety devices or procedures as may be desirable
or as may be specified in safety codes should be provided,
and are neither provided by ABB nor are the responsibility
of ABB. This unit and its associated equipment must be
installed, adjusted and maintained by qualified personnel
who are familiar with the construction and operation of
all equipment in the system and the potential hazards
involved. When risk to persons or property may be
involved, a holding device must be an integral part of the
driven equipment beyond the speed reducer output shaft.
USN 500 and 600 Series Adapter Mount &
®
GENERAL INFORMATION
Dodge USN bearings conform with all appropriate ISO
standards. They are available in either adapter or direct
mounting styles for 40 mm to 160 mm diameter shafts. A wide
variety of seals are available including standard metallic LER,
TRIPLE-TECT™ non-metallic seal with V-ring, Drop-in TRIPLE-
TECT seal with neoprene V-ring, Auxiliary Taconite or Split
non-metallic. TRIPLE-TECT seal is provided as standard on
complete assemblies. DODGE USN housings provide you with
maximum application flexibility. Cast-in dimples allow for easy
field modification for vents, lube ports and sensors. Oversized
drains and an oil equalization hole make USN bearings ready for
circulating oil systems off-the-shelf. For hostile environments,
USN offers optional cast closed end housings, stainless
steel hardware kits, and nickel or nylon coating. Complete
installation, maintenance and modification instructions are
provided in this manual.
INSPECTION
Inspect shaft — Ensure that the shaft is smooth, straight,
clean, and within commercial tolerances.
Inspect bearing — Do not allow bearing to be exposed to any
dirt or moisture. Do not remove preservative compound as it
acts as both a protectant and lubricant and is also compatible
with standard greases.
Note: Housing caps and bases are not interchangeable.
They must be matched with mating half. Install non-
expansion bearing first.
Note: For seal types other than TRIPLE-TECT such as drop-
in TRIPLE-TECT, LER, auxiliary seals and split seals follow
instructions supplied with the seals.
Note: For an explanation of the various dimples and tapped
holes found on the USN housings, see Table 11.
1