Miller XMT 425 CC/CV Manuel du propriétaire - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller XMT 425 CC/CV. Miller XMT 425 CC/CV 40 pages.

When power is applied failed parts can explode or cause other parts to explode.

Always wear long sleeves and button your collar when servicing unit.

After taking proper precautions as shown, connect power to unit.

Do not use one handle to lift or support unit.

Do not weld on drums or any closed containers.

Do not discard product (where applicable) with general waste.

Reuse or recycle Waste Electrical and Electronic Equipment (WEEE) by disposing at a designated collection

facility.

Contact your local recycling office or your local distributor for further information.

Disconnect input plug or power before working on machine.

= < 60°

>60s

OM-257 486 Page 6

Wear hat and safety glasses. Use ear protection and button shirt

collar. Use welding helmet with correct shade of filter. Wear complete

body protection.

Become trained and read the instructions before working on the

machine or welding.

Always lift and support unit using both handles. Keep angle of lifting

device less than 60 degrees.

Use a proper cart to move unit.

Hazardous voltage remains on input capacitors after power is turned

off. Do not touch fully charged capacitors. Always wait 60 seconds

after power is turned off before working on unit, OR check input ca-

pacitor voltage, and be sure it is near 0 before touching any parts.

Safe26 2012−05

Safe28 2012−05

Safe29 2012−05

Safe31 2012−05

Safe16 2012−05

Safe37 2012−05

Safe30 2012−05

Safe38 2012−05

Safe40 2012−05

Safe44 2012−05

Safe42 2012−05