Miller XR Python 25 Ft. Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller XR Python 25 Ft.. Miller XR Python 25 Ft. 24 pages. 200 ampere push-pull welding gun
Également pour Miller XR Python 25 Ft. : Manuel du propriétaire (31 pages)
Imprimer la page
3-1. Specifications
Ref. 803 870-A
3-2. Gun Lead Connections
Power Cable - A #2 AWG power cable is used. The gun end of the cable has a fitting crimped to the copper cable
strands. This fitting is then threaded into the gun body. The cabinet end of the power cable is incorporated into the
Power Pin connector.
Conduit - Poly-lined conduit, for feeding aluminum wire. The longer fitting with a shallow groove is used on the gun
end. A set screw located on top of the gun handle secures the conduit in place. The cabinet end of the conduit is incor-
porated into the Power Pin connector.
Gas Hose - The gas hose is pushed over a barbed fitting on the gun body and secured with a plastic tie wrap. The
cabinet end of the gas hose is incorporated into the Power Pin connector.
Electric Cable - A multi-conductor control cable is used. The gun end of the cable is secured with a cable clamp and
the wires are connected to the potentiometer, the micro switch, the motor and the gun body mechanically. The cabinet
end of the control cable uses a 10-Pin, Amphenol connector.
SECTION 3 − INSTALLATION
Wire Capacity
Aluminum wire - .030 in - 1/16 in (0.8 mm - 1.6 mm) using teflon liner
Cored and Hard wire - .030 in - .045 in (0.6 mm - 1.2 mm) using spiral steel liner
Wire Speed
At rated feeder input voltage - 70-800 Ipm (20.3 mpm)
Duty Cycle - 100% (200 Amps peak)
All ratings are based from using Argon gas
Gun Weight
Less leads − 2.5 lbs (1.13 kg)
Shipping Weight
Approximately 19.29 lbs (8.29 kg)
OM-1500-17 Page 5