Miller XT30 Manuel du propriétaire - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller XT30. Miller XT30 44 pages. Air plasma cutting and gouging
Également pour Miller XT30 : Manuel du propriétaire (40 pages)

Imprimer la page
Miller XT30 Manuel du propriétaire
5-3.

Connecting And Disconnecting Work Cable

A complete Parts List is available at www.MillerWelds.com
5-4.

Connecting Work Clamp

2
�
Complete Parts List is available at www.MillerWelds.com
2
1
1
Ref. 803640-A
Turn off power source and discon-
nect input power.
1 Work Cable Plug
2 Work Cable Receptacle
To connect plug, align key with receptacle
keyway and insert into receptacle. Rotate
plug clockwise (hand tight only) 1/4 turn to
secure in receptacle.
To disconnect plug, rotate counterclockwise
until key aligns with keyway and pull plug
from receptacle.
1 Work Clamp
2 Workpiece
Connect work clamp to a clean, paint-free lo-
cation on workpiece, as close to cutting area
as possible.
OM-253555 Page 17
OM-253555 Page 1