Miller S-75DC Manuel du propriétaire - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller S-75DC. Miller S-75DC 40 pages.

5-8. Installing PD Continuous Wire Guides

PD Continuous Wire Guides:

Should be

used

with

.068/.072 in (1.8 mm) and

smaller diameter wire for opti-

mal performance.

Should be used with PD

drive rolls and cannot be used

with non-PD (old-style) drive

rolls.

70 series wire guides are not

compatible with 75 series wire

feeders.

Pressure Door Assembly

PD Inlet Guide

PD Wire Guide (Hard Wire)

PD Wire Guide (Two Pieces

interlocked for Aluminum

Wire)

Installing PD continuous wire

guides with PD drive rolls.

Drive rolls are identified by the

initials PD and a part number

on the drive roll.

Open pressure door assembly.

Lift up drive roll swing arms.

Remove PD inlet guide.

Insert wire guide gun end (indi-

cated with arrow) into block near

brass power pin gun connector.

Install PD inlet guide.

Do not tighten set screw to se-

cure inlet guide.

Set screw may be used to se-

cure PD inlet guide replace-

ments such as wire straighten-

ers or conduit adapters.

Ref. 804 188-B

OM-223 605 Page 15