Miller CS410A Manuel du propriétaire - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller CS410A. Miller CS410A 20 pages.

Imprimer la page
Miller CS410A Manuel du propriétaire
SECTION 5 − MAINTENANCE & TROUBLESHOOTING

5-1. Routine Maintenance

40 Hours
Replace
unreadable
labels.
Replace cracked parts

5-2. Troubleshooting

.
Before using troubleshooting table, check selection and preparation of tungsten electrode according to Section 7.
Trouble
Arc will not start. High frequency present
and visible at the torch.
Lack of high frequency; difficulty in es-
tablishing arc.
Torch gas valve not working properly (if
applicable).
No shielding gas flow from torch.
Tungsten electrode oxidizing and not re-
maining bright after conclusion of weld.
Excessive tungsten electrode con-
sumption.
Wandering arc
Yellow powder or smoke on cup.
OM-251981 Page 10
Repair or
replace
cracked
weld cable.
Torch Body
Check cable and work connections. Be sure weld circuit is complete (see Section 4-7).
Check and be sure shielding gas is present.
Select proper size and type tungsten. Properly prepare tungsten according to Section 7.
Check cables and torch for cracks or bad connections. Be sure that torch cables are not close to any
grounded metal. Repair or replace necessary parts.
Check torch consumables. Be sure collet and collet body are correctly installed and tightened (see Sec-
tion 4-2).
Check welding power source High Frequency control, and if necessary, check and adjust spark gaps.
Have Factory Authorized Service Station/Service Distributor check valve.
Be sure valves on gas supply are open.
Check cable for kinks or blockage.
Check and tighten all gas supply fittings.
Check cables and torch for cracked insulation or bad connections. Repair or replace (see Section 5-1).
Shield weld zone from drafts.
Increase postflow time.
Increase gas flow rate. Check manufacture's recommendations.
Check and tighten all gas fittings.
Check gas valve and flow meter/regulator.
Select proper size and type tungsten. Properly prepare tungsten (see Section 7).
Select proper size and type tungsten. Properly prepare tungsten according to Section 7.
Check polarity setting on welding power source (see welding power source Owner's manual).
Check for proper gas flow rate. Check manufacture's recommendations.
If torch is water cooled, check torch and cables for water leaks. Repair or replace if necessary (see Sec-
tion 5-1).
Shield weld zone from drafts.
Reduce gas flow rate.
Select proper size and type tungsten. Properly prepare tungsten according to Section 7.
When using AC, check welding power source High Frequency control setting, and increase setting if
necessary.
Use proper type shielding gas.
Check for proper gas flow rate. Check manufacture's recommendations.
Increase postflow time.
Check torch cup size. Match cup size to joint being welded.
!
Disconnect torch before maintaining.
Clean and
tighten weld
terminals.
Torch Cable
Remedy