AQUAPHOR RO-102S Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AQUAPHOR RO-102S. AQUAPHOR RO-102S 16 pages. Reverse osmosis system
Également pour AQUAPHOR RO-102S : Manuel du propriétaire (20 pages)

Imprimer la page

Connection node assembly

• Turn the water off at the cold water main.

• Open the kitchen faucet to discharge pressure

into the water line.

• Unscrew the nut from the flexible line cap,

leading to the faucet on the cold water main.

ATTENTION!

Residual water will be left inside

of the flexible JG tube after discharge of water.

When disconnecting the flexible line, please use

a 200 ml or similar size container to drain the

water left behind in the tube.

• Screw the cap nut off the connection node and

on the cold water main thread.

• Screw the cap nut off the flexible line, and then

on the connection node thread.

• Set the shutoff valve on the connection node

to the closed position and then make sure that

the connection is completely leak-proof by sup-

plying water to the cold water main.

• Connect JG tube (follow the instructions below

to correctly connect the JG tubes).

ATTENTION!

Make sure that the sealing O-Ring

is located correctly in its place and not damaged

during installation.

Figure 5. Connection node installation scheme

Shuto valve set

in closed position

Locking clip

Cold water main

Connection of JG tubes

Pull the locking clip (2) off the plastic plug (1).

Then install the previously wetted end of the

tube (3) into the fitting piece approx.15 mm up

to the stop. Next, put the locking clip (2) back.

Make sure that the tube (3) is tightened correctly:

the tube should not be pulled out by force greater

than 8-10 kgf.

Figure 6. Connection of JG tubes

Disconnection of JG tubes

Pull the locking clip (2) off the plastic plug (1),

then pull the tube (3) out by applying pressure

on the face of the connecting piece. To apply

pressure, use the tube disconnection key (4)

included in the water filter set.

Figure 7. Disconnection of JG tubes

Connection

node

Sealing

O-Ring

6. Clean water faucet

installation

• Drill the hole in the sink (table top) 12 mm

diameter;

• Put on the thread tail of the faucet (11) rubber

gasket (2), decorative stand (3), rubber gasket

(4) and insert the faucet into the hole in the sink;