Chromalox RTAS Instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Chromalox RTAS. Chromalox RTAS 4 pages. Power connection kit with integral thermostat

Imprimer la page

Figure 19A

20. FOR RTAS-EP ONLY:

Trim the blue (NORMALLY OPEN) thermostat wire so that it

is only two inches long. Tape over the end of the wire using

fiberglass tape.) See Figure 20.

21. FOR RTAS-EP WITH OVERCOATED CABLES ONLY:

Slide the bared end of the ground wire into the end of the unin-

sulated barrel connector. Crimp it on using a crimping tool.

Slide the end of the braid pigtail into the other end of the unin-

sulated barrel connector and crimp it on. See Figure 21.

INSTALLATION

Figure 19B

Figure 20

Figure 21

Please refer to the Chromalox limited warranty applicable to this product at

http://www.chromalox.com/customer-service/policies/termsofsale.aspx.

1347 HEIL QUAKER BLVD., LAVERGNE, TN 37086

Phone: (615) 793-3900

22. FOR ALL CABLES:

Mount terminal block to bottom of the box by driving the 6-32

self-tapping screw into the mounting hole as shown. See

Figure 22.

23. FOR ALL CABLES:

The thermostat is shipped factory preset and pre-calibrated for

40°F operation. The setting may be changed by rotating the

white knobs until the desired temperature is directly behind the

setting post.

Carefully push the wires into the box. Secure lid to box. See

Figure 23.

24. FOR CABLES WITH EXPOSED METAL BRAID:

Unravel four inches of braid from the cable and twist into a

pigtail. Insert the end of the pigtail into one end of the uninsu-

lated barrel connector and crimp it on. Connect to appropriate

grounding source.

Limited Warranty:

www.chromalox.com

#6-32

Screw

Figure 22

Figure 23